East Coast Electrical Equipment Company engineers unprecedented quality into all of our remanufactured and rebuilt motors and controls. We have an established contract with Tampa Armature Works repair facilities. TAW has become our one stop source for all your electric motor repair needs. Please visit the TAW web site to learn more about one of the most impressive and established repair facilities in the country.

• State-of-the-art computer controlled VPI tank
• Using Class H insulation is a standard on all Form Coil Motors
• All Formed Coils through 7,200 volts made in-house this allows for quick delivery
• With a 3000 to 7000 lb. ft. Dynamometer, motors up to 3,000 hp and full load tested prior to shipment
• Capacity to test run motors to 15,000 hp allows for temperature stabilization report on even our largest motor demands
• 2 Dynabal 10,000 lb. Balancer has unmatched vibration displacement limits at 1/2 Mil with 3,600 RPM and 1 Mil at 1,800 RPM (Well below NEMA Standards)
• State-of-the-art Current Analysis, Core Loss Testing, Ultrasonic Flaw Detection, Winding Analysis, and Baker Surge Testing
• UL Explosion Proof Approved
• Complete In-house machine shop insures all mechanical fits are correct
• Ability to convert sleeve bearing motors to ball or roller bearing
• Welding, Machining Parts, Fabrication, and Repair Bearings

Our remanufactured transformers are given High Potential Impulse Voltage testing, Turns Ration, Double Induced Voltage, and Core Loss testing before shipment.

Reliability
Reliability and performance are characteristics of East Coast Electrical Equipment Company's finished products. We can provide older equipment, or modern equipment. Our older remanufactured equipment has structural durability, lower current density, and cooler operating temperatures that in some cases are better than today's technologies. Our modern equipment is as good as today's new factory built units at half the cost. Reliability and Performance is a trademark of all our remanufactured equipment.